Coo-Var Chlorinated Rubber White 5Litres

Teamac Chlorvar is a modified chlorinated rubber finish coat for use where resistance to salt water, a wide range of chemicals and acids is required. Interior or exterior use.

Teamac Chlorvar is used as a gloss finish to give protection in moderate to severe corrosive atmospheres. Can be used for swimming pools, parlours, piping, laundries and marine applications. If used for swimming pools, allow to dry completely for 14 days before filling the pool.

Chlorvar is a modified chlorinated rubber finish coat for use over Metaclor Underwater Primer. Resistant to salt water, a wide range of chemicals and acids. Interior or exterior use. It is used as a gloss finish to give protection in moderate to severe corrosive atmospheres. Can be used for swimming pools, parlours, piping, laundries and marine applications. If used for swimming pools, allow to dry completely for 14 days before filling the pool. Not for use over conventional coatings.

Surfaces to be painted should be free from nibs, cavities, and other imperfections. Mould, oil stains, if any, must be removed. Moisture content of concrete should be below 14% prior to application of any coating. Concrete and render should be treated with Coo-Var Acid Etch prior to painting to remove any dirt and laitance and to create a good "key" for the paint. Apply a 10% thinned coat of Teamac Chlorvar to prime and seal the surface prior to applying any unthinned coats. Surfaces previously painted with Teamac Chlorvar and that are in good condition can be scrubbed clean and the surface roughened to help adhesion of the new coating. Old perished Chlorvar coatings should be removed mechanically and treated as new substrate and prepared accordingly.

As dictated by normal good painting practice. In confined spaces, provide adequate ventilation during application and drying.

Teamac Metaclor Underwater Primer on Metal and wood. On Concrete and porous surfaces use Chlorvar thinned 10% with Chlorvar thinners.

Teamac Chlorvar Chlorinated Rubber Paint

Application by brush may require a number of coats to achieve a higher d.f.t. than 25 microns. Not to be used over conventional paint systems as there may be compatibility issues, test first.